Planet SGS-6341-24T4X - Page 803

44-79
no ip dvmrp output-report-delay
Function:
Configure the delay of DVMRP report message transmitted on interface and transmitted message
quantity every time, the “no ip dvmrp output-report-delay” command restores default value.
Parameter:
<delay_val> is the delay of periodically transmitted DVMRP report message, value range from 1s
to 5s.
<burst_size> is a quantity of transmitted message every time, value range from 1 to 65535
Default:
Default the delay of transmitted DVMRP report message as 1s, default: transmitting two messages
every time.
Command Mode:
Interface Configuration Mode
Usage Guide:
Avoid message burst if setting an appropriate delay.
Example:
Switch (Config-If-vlan1)#ip dvmrp output-report-delay 1 1024
44.7.6 ip dvmrp reject-non-pruners
Command:
ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
Function:
Configure to reject neighbor ship with DVMRP router of non pruning/grafting on the interface, the
“no ip dvmrp reject-non-pruners” command restores neighbor ship can be established.
Default:
Default
Command Mode:
Interface Configuration Mode
Usage Guide:
The command determines if it will establish neighboringship with DVMRP router of non
pruning/grafting or not.
Example:
Switch (Config-If-vlan1)#ip dvmrp reject-non-pruners