Planet SGS-6341-24T4X - Page 808

44-84
Any Configuration Mode
Usage Guide:
The command applies to display DVMRP routing table item; DVMRP maintains individual unicast
routing table to check RPF.
Example:
Display DVMRP routiing.
Switch #show ip dvmrp route
Flags: N = New, D = DirectlyConnected, H = Holddown
Network Flags Nexthop Nexthop Metric Uptime Exptime
Xface Neighbor
10.1.35.0/24 .D. Vlan2 Directly Connected 1 00:11:16 00:00:00
13.1.1.0/24 .D. Vlan1 Directly Connected 1 00:10:22 00:00:00
Displayed Information
Explanations
Network
Target net segment or address and mask
Flags
Routing state flag
Nexthop Xface
Next hop interface address
Nexthop Neighbor
Next hop neighbor
Metric
Routing metric value
Uptime
Routing uptime
Exptime
Routing expire time
44.8 Commands for DCSCM
44.8.1 access-list (Multicast Destination Control)
Command:
access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any-source} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function:
Configure destination control multicast access-list, the “no access-list <6000-7999> {deny|permit}
ip {{<source> <source-wildcard>}|{host <source-host-ip>}|any-source} {{<destination>