Planet SGS-6341-24T4X - Page 823

44-99
Command:
ip igmp query-interval <time_val>
no ip igmp query-interval
Function:
Configure interval of periodically transmitted IGMP query information; the “no ip igmp
query-interval” command restores default value.
Parameter:
<time_val> is interval of periodically transmitted IGMP query information, value range from 1s to
65535s.
Default:
Default interval of periodically transmitted IGMP query information to 125s.
Command Mode:
Interface Configuration Mode
Usage Guide:
Periodically transmitting IGMP query information on interface when some interface enables some
group multicast protocol. The command applies to configure this query period time.
Example:
Configure interval of periodically transmitted IGMP query message to 10s
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp query-interval 10
44.9.10 ip igmp query-max-response-time
Command:
ip igmp query-max-response-time <time_val>
no ip igmp query- max-response-time
Function:
Configure IGMP query-max-response-time of interface; the “no ip igmp
query-max-response-time” command restores default value.
Parameter:
<time_val> is IGMP query-max-response-time of interface, value range from 1s to 25s
Default:
10s.
Command Mode:
Interface Configuration Mode
Usage Guide:
After the switch receives a query message, the host will configure a timer for its affiliated every