Agilent Technologies E5071C - Page 2635

E5071C
2862
:SENSe:CORRection:COLLection:DLComp:OPEN
Type
Command Only
Syntax
:SENSe:CORRection:COLLection:DLComp:OPEN
Description
This command executes open measurement, as a part of Loss
Compensation sequence.
Parameter
Description Port number where the open measurement is executed.
Data Type Long integer type (Long)
Range 1 to 4
Preset Value -
Unit -
Resolution -
Examples
10 OUTPUT 717;":SENS:CORR:COLL:DLC:OPEN 1"
20 OUTPUT 717; ":SENS:CORR:COLL:DLC:SAVE"
Related Commands
:SENSe:CORRection:COLLection:DLComp:LOAD
:SENSe:CORRection:COLLection:DLComp:THRU
:SENSe:CORRection:COLLection:DLComp:SAVE
Equivalent GUI
Setup > Deskew & Loss Compensation (under Basic) > Measure
This applies to Single-Ended 1-Port topology only.