Agilent Technologies E5071C - Page 2683

E5071C
2910
Controlling Multiport Test Set by Programming
• Selecting Test Set
• Selecting ports assigned to Port 1 to Port n
• Difference between E5092A and E5091A
• Sample program
Other topics about Controlling Multiport Test Set
Selecting Test Set
The multiport test set provides test set 1 and test set 2. To select the test
set, use the following command:
:SENS:MULT{1-2}:NAME
The following models are available for the test set:
Multiport Test Set Option
E5092A E5092_13 Option 020 (13-port measurement)
E5092_16 Option 020 (16-port measurement)
E5092_22 Option 020 (22-port measurement)
E5092_28 Option 020 (28-port measurement)
E5092_X10 Option 020 (X10-port measurement)
E5091A E5091_9 Option 009
E5091_13 Option 013 (13-port measurement)
E5091_16 Option 016 (16-port measurement)
Checking the name of available test set
To check the name of the available multiport test set, use the following
command:
:SENS:MULT:CAT?
Turning control ON/OFF
To turn ON/OFF the control of the multiport test set, use the following
command:
:SENS:MULT{1-2}:STAT