E5071C
760
signal
generator
enabled (SENS:OFFS:LOC:STAT ON and
SENS:OFFS:LOC:CONT ON).
Ensure the connection of the external signal
source.
102
Failed to
copy file
This error occurs when copying a file
(MMEM:COPY command) fails.
104
Failed to
create
directory
This error occurs when creating a directory
(MMEM:MDIR command) fails.
103
Failed to
delete file
This error occurs when deleting a file (MMEM:DEL
command) fails.
600
Failed to
simulate
eye
This error occurs when eye diagram simulation
fails.
100
Failed to
read file
This error occurs when a 2-port touchstone file
(CALC:FSIM:SEND:PMC:PORT:USER:FIL
command), the formatted data array
(MMEM:LOAD:FDAT command) and limit table
(MMEM:STOR:LIM command) for the active trace
on the active channel, segment sweep table
(MMEM:LOAD:SEGM command) for the active
channel, a VBA project file (MMEM:LOAD:PROG
command), etc. cannot be read normally.
601
Failed to
read bit
file
This error occurs when reading bit file fails.
101
Failed to
write file
This error occurs when the formatted data array
(MMEM:STOR:FDATcommand) and limit table
(MMEM:STOR:LIM command) for the active trace
on the active channel, segment sweep table
(MMEM:STOR:SEGM command) for the active
channel, display image (MMEM:STOR:IMAG
command) for the LCD screen, a VBA project file
(MMEM:STOR:PROG command), etc. cannot be
written normally.
- File name A file name error. This message appears when an
error exists in the file name and hence a
To Next Page
Loading...
Need help?
General
