CCW-R-2**B INSTRUCTION MANUAL 6 FUNCTIONS OF THE OPERATION SCREENS
6-17
6.3.4 Operation Level Selection
In the [Main Menu] screen, press the [Operation Level Selection] drop-down key to display the
menu to select the operation level.
There are four operation levels: [Operator] level, [Site Engineer] level, [Installation] level, and
[Maintenance] level. Operable items differ depending on the operation level.
In this section, the levels except for the [Maintenance] level are described in “Table 6-3 Operation Level
List”.
The operation panel is set to the [Operator] level as default when power is turned on.
To switch the [Operator] level to a higher level, a password for the higher level is required.
Passwords are registered as the factory setting shown in the table below. To change the passwords, refer
to “6.3.5.2 [Password Set/LangSlct Set] Tab Screen in the [Control Panel] screen.
When switching from higher operation levels to a lower level, no password is required.
• Passwords for the [Site Engineer] and higher operation levels are set in order
to limit operations to authorized users for each operation.
Passwords need to be managed to avoid operation by unauthorized users.
Refer to the following sections for changing the operation level.
Table 6-3 Operation Level List
Operation Level
Name
Authorized User
for Operation
Operation Details Password
[Operator] level Operators Basic operations for daily production line
work.
Not required Lower level
↑
Higher level
↓
[Site Engineer] level System
administrators
In addition to the [Operator] level
operations, registration for weighing and
adjustment operation.
Required
[Installation] level Maintenance
engineers
In addition to the [Site Engineer] level
operations, adjustment and other
operations required for installation of
equipment.
Required
Table 6-4 Factory Default Password
Operation Level Password
[Site Engineer] level 1
[Installation] level 2
To Next Page
Loading...
Need help?
General
