ISHIDA CCW-R-2 B Series User Manual

CCW-R-2**B INSTRUCTION MANUAL 10 MAINTENANCE AND INSPECTION
10-5
10.3 Periodical Inspection
Perform maintenance and inspections by following “Table 10-4 Periodical Inspection Items” in order to
maintain the weighing machine in good condition and enhance the product efficiency.
Table 10-4 Periodical Inspection Items
Inspection Item Cycle Reference Section
Inspection of the span Monthly
10.3.1 Inspection of Span
(Monthly)
Inspection of the open/close for each hopper gate Monthly
10.3.3 Inspection of Open/Close
for Hopper Gate (Monthly)
Inspection of the open/close roller for each hopper Monthly
10.3.4 Inspection of Open/Close
Roller for Hopper (Monthly)
Inspection of the amplitude strength for radial feeder Monthly
10.3.5 Inspection of Amplitude
Strength for Radial Feeder (Monthly)
Inspection for cracks Annually
10.3.6 Inspection for Cracks
(Annually)
Inspection of the rubber cover Annually
10.3.7 Inspection of Rubber
Cover (Annually)
Replacement of the memory backup battery Approx. every five
years
10.3.8 Replacement of Memory
Backup Battery
Replacement of fuses As needed
10.3.9 Replacement of Fuses
Replacement of the air dryer element(WP specification) Annually
10.3.10 Replacement of the Air
Dryer Element (WP specification)
Replacement of the air dryer module set(WP specification) Annually
10.3.11 Replacement of the Air
Dryer Module Set (WP specification)

ISHIDA CCW-R-2 B Series Specifications

General

Brand	ISHIDA
Model	CCW-R-2 B Series
Category	Industrial Equipment
Language	English