ISHIDA CCW-R-2 B Series User Manual

9 CLEANUP PROCEDURES CCW-R-2**B INSTRUCTION MANUAL
9-4
• At position A in the above drawing, a diaphragm is connected to the weight sensor. This part
is extremely sensitive. When any washing method other than instructed is used, malfunctions
may occur due to liquid intrusion.
1. Do not use air apparatus with nozzles to dry out position A. It may break the diaphragm.
2. Do not use tools such as a brush or any tools with sharp parts to dry out position A. It may break
the diaphragm.
9.3 Washing and Sterilization Methods
The recommended standard methods for washing and sterilizing are described in “Table 9-1 Washing
and Sterilizing Methods”.
For the details of each component, read “9.4 Washing and Sterilizing of Components” thoroughly.
• Washing and sterilizing methods differ depending on product types,
processing methods, and bacterial conditions.
Create a washing and sterilization manual, and perform washing and
sterilization work daily. For creating a manual, refer to Table 9-1.
For details, contact the distributor or Ishida customer support.
• For the unremovable units and parts, washing and sterilization methods differ
depending on the machine specifications (mainly the specifications of
waterproof and dustproof construction).
This can be verified by determining whether the name of your device ends with
“WP”, “PB” or “SS”.
For details, contact the distributor or Ishida customer support.
[Example]
CCW-R-*-WP: equivalent to IP66
CCW-R-*-PB, SS: equivalent to IP50
• After washing and sterilization, always dry. Failure to do so may cause
microorganism development.
• If spot welding causes the development of bacteria, contact the distributor or
Ishida customer support.

ISHIDA CCW-R-2 B Series Specifications

General

Brand	ISHIDA
Model	CCW-R-2 B Series
Category	Industrial Equipment
Language	English