CCW-R-2**B INSTRUCTION MANUAL 11 CAUSES AND ACTIONS FOR ERRORS AND FAILURES
11-15
11.2.7 Pattern 7
If an error occurs during operation or draining, the weighing machine stops automatically and the power
is turned off automatically.
In addition, an error screen is displayed on the screen of the remote control unit.
When a Pattern 7 error occurs, refer to “Table 11-8 Error Display List (Pattern 7)” to perform the
correcting action.
If the error still occurs, contact the distributor or Ishida customer support to request repair service.
11.2.8 Pattern 8
When the file transfer fails, warning alarm sounds.
In addition, an error screen is displayed on the screen of the remote control unit.
When a Pattern 8 error occurs, refer to “Table 11-9 Error Display List (Pattern 8)” to perform the
correcting action.
Table 11-8 Error Display List (Pattern 7)
Error Name/
Error Description
Cause Action
[ADC firmware error] 1. System error. 1. Turn off the main power switch and turn it on
again.
2. If repair cannot be achieved by the above action
1, contact the distributor or Ishida customer
support to request repair service.
Table 11-9 Error Display List (Pattern 8)
Error Name/
Error Description
Cause Action
FILE TRANSFER ERROR 1. The ftp server is down.
2. The network is disconnected.
1. Contact the network administrator.
To Next Page
Loading...
