ISHIDA CCW-R-2 B Series - Installation Procedure

CCW-R-2**B INSTRUCTION MANUAL 12 INSTALLATION
12-7
12.4 Installation Procedure
The overview for the weighing machine installation procedure is described below.
For details of each procedure, refer to the following reference section.
• After installing the weighing machine, perform check and adjustment of the installation
condition.
( 12.5 Check and Adjustment After Installation)
Table 12-2 Installation Procedures
Unpacking the weighing machine ( 12.4.1 Unpacking Procedure)
↓
Checking the weighing machine ( 12.4.2 Checking Weighing Machine)
↓
Carrying in and installing the weighing machine
( 12.4.3 Carrying in and Installing the Weighing Machine)
↓
Connecting the power cable and remote control unit
( 12.4.4 Connecting Power Cable and Remote Control Unit)
↓
Installing the timing hopper frame
( 12.4.5 Installing Timing Hopper Frame)
↓
Installing the signal wire for the timing hopper
( 12.4.6 Connecting TH Signal Wire)
↓
<Installing components to the main body>
Installing the timing hopper ( 12.4.7 Installing Timing Hopper)
Installing the discharge chute ( 12.4.8 Installing Discharge Chute)
Installing the collection chute ( 12.4.9 Installing Collection Chute)
Installing the radial trough ( 12.4.10 Installing Radial Trough)
Installing the dispersion table ( 12.4.11 Installing Dispersion Table)
Installing the booster hopper ( 12.4.12 Installing Booster Hopper)
Installing the weigh hopper ( 12.4.13 Installing Weigh Hopper)
Installing the pool hopper ( 12.4.14 Installing Pool Hopper)
↓
Connecting to the interlocking device
( 12.4.15 Connecting to Interlocking Device)