ISHIDA CCW-R-2 B Series User Manual

CCW-R-2**B INSTRUCTION MANUAL 12 INSTALLATION
12-3
12.3 Transportation and Lifting
This section describes the precautions for the transporting and lifting of the weighing machine and lifting
procedures. Understand them beforehand in order to avoid accidents during the installation of the
weighing machine.
• When transporting or lifting the weighing machine, always observe the
following safety precautions, customer safety standard, and relevant national
and local laws.
If they are not observed, injuries, fatal accidents or damage to the weighing
machine may occur.
12.3.1 Precaution for Transporting
When transporting the weighing machine, observe the following items:
1. Place a “match mark” on the pipes, connections, and fitting portions, and do not remove the “match
mark” during transportation.
2. Seal the pipes and openings with removable sealing caps, and remove the caps on site immediately
before reassembling. Protect the protruding part of the male screws with cloth or similar material.
3. When it is necessary to disconnect the electric cables for transportation, tie the cable ends by groups,
cover with vinyl or similar material for protection, and transport to the site. Remove the cover
immediately before the installation of the weighing machine.
4. When moving the packaged weighing machine by forklift, securely insert the fork into the specified
positions.

ISHIDA CCW-R-2 B Series Specifications

General

Brand	ISHIDA
Model	CCW-R-2 B Series
Category	Industrial Equipment
Language	English