ISHIDA CCW-R-2 B Series - Selecting and Copying Preset

CCW-R-2**B INSTRUCTION MANUAL 6 FUNCTIONS OF THE OPERATION SCREENS
6-133
6.15.3.2.1 Selecting and Copying Preset
This section describes the procedure to select and copy the preset data registered in the memory or card.
• When data is already registered in the specified copy destination, the data is overwritten by
the copied data if [Copy] is executed.
1. Press the [Source] drop-down key and
select the copy source from the following: [C1
Memory], [C2 Memory], [C1 Card] or [C2
Card].
Fig.6-135 [Preset Manager] Tab Screen
([Display & Data Manager] Screen)
2. From the copy source preset list, press the
preset number to be used as the copy source.
X The selected copy source preset item is
displayed in blue.
X On the left of the [Copy] key, the selected
copy source preset number is displayed.
Fig.6-136 [Preset Manager] Tab Screen
([Display & Data Manager] Screen)