CCW-R-2**B INSTRUCTION MANUAL 5 REGISTERING OF PRODUCTS
5-5
5.2.2 Outline of the Registration
This section describes the outline of the product registration for the double weigher.
Refer to the next section for details regarding the operation procedures.
Items for C1 and C2 should be registered respectively for the double weigher.
For items marked with * in the following chart, respective initial values are registered. Refer to “5.2.1
Registration Details” for each initial value.
Refer to “6.11 [Preset] Screen” for detailed descriptions of all items in the following chart.
Selecting the machine ( 5.2.3.1 Selecting the Machine)
↓
Setting the product ( 5.2.3.2 Setting the Product)
Product name, product code, product category, selecting photos, and taking photos
↓
Setting the machine ( 5.2.3.3 Setting the Speed)
Speed, dump count*, average control*, interlock parameter number*, and section parameter number*
↓
Setting the item*
Auto feed target, disch. priority count, AFD auto adjustment limit amp, AFD auto adjustment limit time, feed
multiplier, hopper action parameter number, photo SW, and shutter drive
↓
Other settings*
Stable time and BH non sync feeding
↓
Setting the feeder value*
↓
Setting the timing value*
↓
Setting the weight value ( 5.2.3.4 Setting the Weight Value)
Target weight, extended upper limit, upper weight limit, and lower weight limit
↓
Presetting other channels ( 5.2.3.5 Presetting Other Channels)
Return to the machine selection procedure when registering C2.
↓
Completing the preset operation
To Next Page
Loading...
Need help?
General
