ISHIDA CCW-R-2 B Series - Page 327

CCW-R-2**B INSTRUCTION MANUAL 9 CLEANUP PROCEDURES
9-17
1. Remove the parts below by following the
procedures in 9.4.1.1 to 9.4.1.7.
• Inlet chute
• Dispersion table
• Radial trough
• Pool hopper
• Weigh hopper
• Booster hopper
• Collection chute
• Discharge chute
• Timing hopper
2. In accordance with the specifications, wash,
sterilize and dry the device. (For the washing
and sterilization methods, refer to “Table 9-11
Washing and Sterilization Methods of Main
Body, Dispersion Portion, and Drive Portion
(WP Specification)” and “Table 9-12 Washing
and Sterilization Methods of Main Body,
Dispersion Portion, and Drive Portion (PB, SS
Specification)”)
3. Reinstall in the reverse order of the removal.
4. Make sure that each part is installed securely.
Fig.9-17 Main Body, Dispersion Portion,
and Drive Portion
RUBBER COVER
FOR DISPERSION
FEEDER
RUBBER COVER FOR
RADIAL FEEDER
MAIN
UNIT
WH
HANGER
DISPERSION
UNIT
DRIVE
UNIT