ISHIDA CCW-R-2 B Series User Manual

CCW-R-2**B INSTRUCTION MANUAL 11 CAUSES AND ACTIONS FOR ERRORS AND FAILURES
11-7
**ERROR
/POWER ERROR
There is no power supplied to
the motor.
(**: PH, WH, BH, RS, TH,
and DTH)
1. The fuse in the main body is blown.
• This error occurs when the power is
not supplied to the drive unit.
1. Replace the fuse.
**ERROR
/DRIVE PATTERN CALC
ERROR
(**: PH, WH, BH, RS, TH,
and DTH)
1. Setting of the hopper action parameter is
improper.
1. Initialize the setting of the drive
specification.
**ERROR
/DRIVE PARAMETER
NON-RECEPTION ERROR
(**: PH, WH, BH, RS, TH,
and DTH)
1. Communication is interfered due to momentary
power loss of the power supply. (A failure in the
communication line inside the weigher.)
2. The drive unit was requested to drive before
receiving the drive parameters from the remote
control unit.
1. Turn off the main power switch and
turn it on again.
**ERROR
/CYCLE OVERLAP ERROR
(**: PH, WH, BH, RS, TH,
and DTH)
Hopper opening and closing are overlapped.
• This error occurs when attempting
to operate the running drive unit of
TH, DTH or RS in the next cycle.
1. The setting of the weigher speed is too
high. Lower the weigher speed.
[PIECE WEIGHT ERROR]
/Please check current piece
weight.
1.The updated piece weight exceeds the piece
weight revision range.
• This error occurs when the count
set weighing (optional) is used.
1. The setting of the weigher speed is too
high. Lower the weigher speed.
Table 11-2 Error Display List (Pattern 1) (Continued)
Error Name/
Error Description
Cause Action

ISHIDA CCW-R-2 B Series Specifications

General

Brand	ISHIDA
Model	CCW-R-2 B Series
Category	Industrial Equipment
Language	English