ISHIDA CCW-R-2 B Series - Page 357

CCW-R-2**B INSTRUCTION MANUAL 11 CAUSES AND ACTIONS FOR ERRORS AND FAILURES
11-9
[NETWORK ERROR]
/DUC NODE SETTING
ERROR
1. Error has occurred in the
communication network.
• This error occurs when the
CPU or board is damaged.
1. Contact the distributor or Ishida customer
support to request repair service.
[RECHECK ERROR] 1. The result of the combination by count
is not within “target weight - lower
weight limit” and “target weight +
upper weight limit”.
• This error occurs when the
count set weighing
(optional) is used.
1. Check the set value of the upper and lower
weight limits.
[FDRV ERROR] 1. Error has occurred in the
communication network.
• This error occurs when
there is a failure in the
communication line.
1. Contact the distributor or Ishida customer
support.
Table 11-3 Error Display List (Pattern 2) (Continued)
Error Name/
Error Description
Cause Action