OBJECTIVES AND ORGANIZATION OF THIS MANUAL
(6)
3.Illustrations and notations used in this manual
1. Illustrations of the equipment
The illustrations used to describe the operation
procedures are drawn in the most general shapes.
The actual equipment may differ slightly from
the illustrations.
2. Descriptions for key operations
Most operations of the equipment are performed by touching the virtual keys displayed on the
operation screen of the remote control unit.
In this manual, the operations by touching these keys displayed on the screen are described as
follows:
Example: Press the [XXX] key .
3. Notations used in this manual
In this manual, the following notations are used in order to make understanding of the information
easier.
Notation Description
Is used for imminent hazardous conditions that could cause death or serious injury, if
not prevented.
Is used for hazardous conditions that could cause death or serious injury, if not
prevented.
Is used for hazardous conditions that could cause light or moderate injury, or that
could damage equipment or devices, if not prevented.
Is used for cautionary or important information to be noted or emphasized.
Is used to indicate what you must not perform.
Is used to indicate what you must perform.
Is used to indicate reference information for operations or information which helps
understanding of the device.
Is used to indicate sections to be referred to during operations.
To Next Page
Loading...
Need help?
General
