Matrix ETERNITY NE - Page 237

Matrix ETERNITY NE System Manual 227
Send CLI
1. Define the CLI of the SIP Trunk to be sent to the remote party on outgoing calls made using this SIP trunk.
You may select any of the following Send CLI options as desired:
• CLIR: Select this option if you do not want the CLI to be sent.
• SIP ID: You may select this option if you want the SIP ID programmed on the SIP Trunk to be sent as
CLI.
• Calling Party-wise: Select this option if you want to send the Calling Extension Number (i.e. the
number of the extension making the outgoing call through the SIP trunk) as CLI.
The DDI number assigned to the calling extension will be sent, instead of its extension number.
If the calling extension has disabled the parameter ‘Send DDI as CLI’, then its Pilot number configured
in the DDI Routing on this SIP Trunk will be sent as CLI.
If calling extension has enabled CLIR, no CLI will be sent by this SIP Trunk.
• Fixed Number: Select this option if you want a specific number to be sent as CLI. When you select this
option, you must also define the number to be sent as CLI.
You may select this option you want to send any of your trunk line numbers as CLI on the SIP Trunk so
as to enable the called party to call back the calling party using this CLI.
Since it is not possible to call back a SIP ID, Fixed Number offers you a solution, using which you can
send a trunk line number as CLI on the SIP Trunk. Using this CLI, the called party can call back the
calling party.
The Fixed Number may consist of a maximum of 40 characters, including all ASCII characters.
By default, ‘SIP ID is set as the Send CLI option for all SIP Trunks.
When extension number of the calling extension is blank, and the ‘Send CLI Option’ programmed for the
the SIP Trunk is other than "SIP ID", then also SIP ID will be sent as CLI.