Matrix ETERNITY NE - Page 236

226 Matrix ETERNITY NE System Manual
Call Back
Configure this parameter if you want to enable the ‘Call Back on Trunk Port’ feature on the trunk. See “Call Back on
Trunk Ports” to know more.
1. Select a Call Back Profile, 1 to 4, for the trunk port from the combo box.
Make sure you also configure the Call Back profile you select here.
To configure the profile, click the settings icon.
• A new window opens.
• Configure the Profile Number. See “Call Back on Trunk Ports” for instructions.
• Click Submit to save your profile.
• Close the window.
DTMF Out Dial
This parameter is applicable for the “Multi-Stage Dialing” feature.
1. Set the time for which the DTMF digit should remain ON while being dialed out by the ETERNITY NE as
DTMF ON Time.
The range of this timer is from 051 to 255 milliseconds. Default: 102 msec.
2. Set the time for which ETERNITY should wait before dialing the successive DTMF digits as Inter Digit
Pause Time. The range of this timer is from 051 to 255 milliseconds. Default: 102 msec.
3. Set the time for ----- as Pause Time (sec). The range of this timer is from 1 to 9 seconds. Default: 1
second.
• Pause Timer (sec): This parameter is used for the “Multi-Stage Dialing” feature. This Timer is required for
inserting delay while digits of a number string are out dialed from the SIP trunk. The Pause Timer will be
applicable when the letter 'P' is configured in the DTMF number string which is to be out dialed as DTMF
digits on the SIP trunk. The range of this timer is from 1 to 9 seconds. By default the Timer is set to 3
seconds.
For example, if 'PPP7' is to be out dialed and Pause timer is programmed as 3 seconds, the ETERNITY
will out dial the digit 7 after 9 seconds, i.e. after a delay of individual P (i.e. 3+3+3 =9). The range of this
Timer is from 1 to 9.