Matrix ETERNITY NE - Page 395

Matrix ETERNITY NE System Manual 385
• Number of Units is derived from the pulse rate at the time of the call and duration of the call. System
acquires the pulse rate type and call duration with the help of in-built RTC.
Total Units = First Unit + Additional Unit.
• If the call duration is less than the pulse rate of the first unit then additional unit is zero and total units. Call
units when call answer supervision type is 12/16KHz metering.
Call Units = (Call duration in seconds)/(Pulse rate in seconds).
ETERNITY uses the Cost of the Call for SMDR and also to deduct it from the Call Budget (Amount), if allotted to
the trunk.
The logic for call cost calculation is explained by following example:
• A Outgoing Call is made on trunk, CO-1.
• On CO-1, Call Cost Calculation is configured as follows:
• Call Cost Calculation Pulse Rate option = 1
• Call Cost Calculation Schedule
• Time Zone 1 = Start Time: 00:00, End Time: 22:00
• Time Zone 2 = Start Time: 22:01, End Time: 23:59
• Area Code Table is configured as:
• The Pulse Rate Table is configured as:
Index
Area
Code
Name
Ignore
Digit
Count
Pulse Rate
Type for
Pulse Rate
Option - 1
Pulse Rate
Type for
Pulse Rate
Option - 2
Pulse Rate
Type for
Pulse Rate
Option - 3
Pulse Rate
Type for
Pulse Rate
Option - 4
001 26 Local 03 06 09 10
002 09 Mobile 05 03 07 08
Pulse Rate Type
Time Zone T1 Time Zone T2 Time Zone T3 Time Zone T4
First
Unit
Add.
Unit
First
Unit
Add.
Unit
First
Unit
Add.
Unit
First
Unit
Add.
Unit
01
Duration (sec) 180 180 60 30 90 30 120 60
Cost 02.00 02.00 02.00 02.00 02.00 02.00 02.00 02.00
02
Duration (sec) 300 300 300 300 300 300 300 300
Cost 01.00 01.00 01.00 01.00 01.00 01.00 01.00 01.00
03
Durations) 3030303030303030
Cost 01.00 01.00 01.00 01.00 01.00 01.00 01.00 01.00
04
Duration (sec)4545454545454545
Cost 01.00 01.00 01.00 01.00 01.00 01.00 01.00 01.00