Matrix ETERNITY NE System Manual 479
When there are trunks connected directly to the network and you want to allow extension users to access
these trunks without dialing the Trunk Access Codes for these trunks, enable LCR to select the lowest cost
trunk from these trunks.
• In the Dialed Digit Count field, enter the digit length of the extension numbers of the other PBX in the
CUG. The digit length may be up to 99. Default: 99.
• Double click the Route using Trunks field. A multiple selection box opens.
• On the left, the trunks appear with their names (if configured in “Naming Trunks”) and port numbers in a
sequence, starting with CO trunks, followed by Mobile trunks and SIP trunks.
If you have not assigned any names to the trunks, they will appear with their default names (CO, MOB,
SIP) and port numbers.
If you have enabled On-Site Configuration, only those trunks that are connected will appear in the box.
• To select a trunk, place your cursor on the desired trunk, and click the Select>> button.
Or
• Press the ctrl key and click the left mouse button to select multiple trunks.
• You may change the sequence of the trunks you selected, if required, using the Up and Down arrow
buttons on the right display box.
• You can also delete trunks from the ones you have selected.
• You may enable Rotation, if you have selected more than one trunk. Default: Disabled.
When you enable Rotation, each new outgoing call is routed through the subsequent trunk in the
group
30
. This ensures equal distribution of outgoing call traffic on all trunks.
30. The first call through the first trunk, the second through the second, the third through the third trunk, and so forth. Thus each new
call is routed through the trunk next to the one that routed the previous outgoing call.
To Next Page
Loading...
