Matrix ETERNITY NE System Manual 41
3. Connect the Handset to the Phone body.
• Plug the long straightened end of the phone cord into the handset jack at the bottom of the phone
marked with the handset symbol.
• Plug the other (short straight) end of the phone cord into the jack at the bottom of the handset.
4. If you want to use a Headset (not supplied) with your phone, you may plug a headset with a 2.5 mm single
connector into the headset jack on the left side panel of the phone.
OR
You may plug a headset with an RJ11 connector in to the headset port at the bottom of the phone.
5. Connect the LAN Port of SETU VP248 to the LAN Switch/Hub.
6. To connect your phone to a computer on your desk, use an Ethernet cable (not supplied with this phone) to
connect the PC Port of the phone with LAN Port of the computer.
7. Plug the connector of the Power Adapter in to the power jack at the back of the phone
5
. Use only the
adapter provided with the phone to prevent any damages that may arise from the use of other adapters.
If you want to use Power over Ethernet (PoE), ensure that your LAN supports PoE. Supply power through
an 802.3af connection on the LAN Port of the phone. Do not connect the Adapter!
8. Plug the Power Adapter into a power outlet.
9. Switch ON power supply.
5. The SETU VP248 does not have a power switch.
To Next Page
Loading...
