738 Matrix ETERNITY NE System Manual
In the Static Routing Table, you must configure:
• The address of the final Destination where the packets are to be sent.
• The Subnet Mask to be applied on the final destination address.
• The Gateway Address where the IP packets are to be sent.
When ETERNITY NE sends packets, if the final destination IP Address and ETERNITY NE are not in the same
Subnet, the system will check the Static Routing Table.
If a perfect match is found, ETERNITY NE will start sending the IP packets to the corresponding Gateway Address
configured in the table.
If no match is found, ETERNITY NE will send the IP Packets to the Default Gateway Address (Network
Connection Type) you configured in “Network Parameters” the page.
The Static Routing Table is common for all SIP Trunks.
How to configure
The Static Routing Table must be configured at each location where ETERNITY NE is installed.
To configure the Static Routing Table,
• Open Jeeves.
• Log in as System Engineer.
• Click the Advanced Settings link to expand.
• Scroll the advanced settings to reach Network Parameters.
• Click the Network Parameters link.
• Click the Static Routing Table link. The Static Routing Table page opens.
To Next Page
Loading...
