Matrix ETERNITY NE - Page 749

Matrix ETERNITY NE System Manual 739
The Static Routing Table allows you to configure up to 8 entries. Each entry is stored against an Index
number.
For each entry, you must configure the following fields:
• Destination Address: This is the address of the final destination where the call is to be made. This
can be a device IP Address or Network Address.
• Subnet Mask: This is the mask to be applied on destination address.
• Gateway Address: This is the IP address of the node where the IP packets are to be sent. Generally,
it is the IP address of the LAN interface of the Router.
The Gateway Address must be in the same subnet as ETERNITY NE.
• Click Submit to save your entries.
To take the above example further, the Static Routing Table of ETERNITY NE at Location A should be
configured as:
• The Destination Address 192.168.2.0 specifies the network address of Location B.
• The Subnet Mask is the mask to be applied on the Destination address.
• The Gateway Address 192.168.1.1 specifies the LAN address of the Router A which connects location
A and location B.
The IP address of the LAN interface of the router which connects Location A to the public internet
should be configured as Default Gateway in the Network Parameters of ETERNITY NE in location A.
With the Static Routing Table configured thus, all calls made by ETERNITY NE to 192.168.2.0/ 24 will
be routed through the router which connects Location A to Location B. Whereas, all calls made by
ETERNITY NE to address other than 192.168.2.0/ 24 will be routed through the Default Gateway.
Similarly, configure the Static Routing Table in ETERNITY NE at location B to enable calling from
Location B to Location A.
Index Destination Address Subnet Mask Gateway Address
1 192.168.2.0 255.255.255.0 192.168.1.1
2
:
8