Matrix ETERNITY NE - Page 801

Matrix ETERNITY NE System Manual 791
• Units: The duration of the call interpreted in terms of units. The number of units depends on the Pulse
Rate. The number of units is derived from the Call Unit = Call duration in seconds/Pulse rate in
seconds.
• Amount: This is the Amount of the call. Program the amount format and the fill flag.
• Filler Character field is applicable for both the sub fields of Amount viz. Rupees/Paisa i.e. whether the
single digit Rupee is to be printed as space-X or 0-X. For example, Rupee = 1 is to be displayed as '1'
or '01'. Where leading zeroes are not required, the Rupee and Paisa are right aligned and the spaces
are filled with character 'space'.
• When Amount Format = Higher Currency, rounding to nearest whole number is done. For Lower
Currency <= 50, Higher Currency is not incremented and for Lower currency > 50, Higher Currency is
incremented.
• Currency: This is the symbol of the currency in which the Amount is charged. A maximum of 8 ASCII
Characters are allowed.
• Generally, Currency Symbol field prefixes to Amount field. Hence, to comply with various CDR formats,
it is recommended that the column position of Currency Symbol and Amount field should be
programmed properly.
• You can change the Currency Symbol used in the OG-SMDR Format.
• Call Type Indicator: This indicates the type of call made, i.e. whether local, national or international.
Define the Call Types in the “Call Type Indicator”.
• Location: This column indicates the location of the external number to which the call was made.
The system detects the location from the called location programmed in the Area and Country Code
Tables.
Called Location is programmed as one of the parameters of the Area Code Table and Country Code Table.
Depending upon the prefix dialed, the Location string is picked up from either Country Code table or Area
Code table.
Called Location is not displayed for Local Calls.
The Called Location parameter in the Country Code table and Area Code table is of 8 Characters.
If the number of characters in the field Called Location is more than Field length then the remaining
characters will not be printed (overlapped by next field).
If the number of characters in the field Called Location is less than Field length then the remaining
characters in the field Called Location will be filled by spaces.
• Called Number: This is the external number to which the call was made.