52-5
Switch#debug aaa detail event
52.8 debug aaa error
Command:
debug aaa error
no debug error
Function:
Enable the debug information of aaa about errors; the no operation of this command will disable that
debug information.
Command Mode:
Admin Mode.
Usage Guide:
By enabling the debug information of aaa about errors, users can check the information of all kinds
of errors that occurs in the operation process of Radius protocol, which might help diagnose the
cause of faults if there is any.
Example:
Enable the debug information of aaa about errors.
Switch#debug aaa error
52.9 radius nas-ipv4
Command:
radius nas-ipv4 <ip-address>
no radius nas-ipv4
Function:
Configure the source IP address for RADIUS packet sent by the switch. The “no radius nas-ipv4”
command deletes the configuration.
Parameter:
<ip-address> is the source IP address of the RADIUS packet, in dotted decimal notation, it must be
a valid unicast IP address.
Default:
No specific source IP address for RADIUS packet is configured, the IP address of the interface from
which the RADIUS packets are sent is used as source IP address of RADIUS packet.
Command mode:
To Next Page
Loading...
