Planet SGS-6341-24T4X - Page 1116

67-1
Chapter 67 Commands for sFlow
67.1 sflow agent-address
Command:
sflow agent-address <agent-address>
no sflow agent-address
Function:
Configure the sFlow sample proxy address. The “no” form of this command deletes the proxy
address.
Parameter:
<agent-address > is the sample proxy IP address which is shown in dotted decimal notation.
Command Mode:
Global Mode.
Default:
None default value.
Usage Guide:
The proxy address is used to mark the sample proxy which is similar to OSPF or the Router ID in
the BGP. However it is not necessary to make the sFlow sample proxy work properly.
Example:
Sample the proxy address at global mode.
switch (config)#sflow agent-address 192.168.1.200
67.2 sflow analyzer
Command:
sflow analyzer sflowtrend
no sflow analyzer sflowtrend
Function:
Configure the analyzer used by sFlow, the no command deletes the analyzer.
Parameter:
sflowtrend is the analyzer of Inmon.
Command Mode:
Global Mode
Default: