CCW-R-2**
Ｂ
INSTRUCTION MANUAL 4 OPERATION PROCEDURES
4-11
• On the [DF Zero Adjustment] screen,
the dispersion table is displayed in blue.
When the dispersion table is displayed
in red immediately after power-on, it is
not possible to proceed to the next step
until the zero adjustment is performed.
10. Press the [Start] key .
Fig.4-19 [DF Zero Adjustment] Screen
(Start-up Assistant Function)
X Zero adjustment operation for the dispersion
table starts.
X When the zero adjustment operation for the
dispersion table finishes without error, the
[Production Standby] screen appears.
The progress bar is displayed during zero
adjustment.
• When an error occurs during zero
adjustment, the dispersion table is
displayed in red. In this case, press the
[Start] key again and perform
zero adjustment.
Fig.4-20 [In DF Zero Adjst] Screen
(Start-up Assistant Function)
11. Press the [Start] key .
X The production starts.
Fig.4-21 [Production Standby] Screen
(Start-up Assistant Function)
To Next Page
Loading...
