EasyManua.ls Logo

Philips iE33 - System Inspection

Philips iE33
480 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4535 611 98931 iE33 Service Manual Page 109
CSIP Level 1 Installation: System Inspection
WARNING Use caution when removing the strapping bands securing the shipping container. These bands are
under enough tension to cause injury if removed carelessly.
System
Inspection
Introduction
NOTE Some parts of this section include policies, equipment requirements, and procedures
that may apply only to U.S. field use. Distributors, affiliates, or other authorized service
personnel should use their equivalent document.
Perform a site inspection as described in “Introduction” on page 104. After you have completed
the inspection and installation of the system, verify the correct operation as described in “Per-
formance Tests” on page 193.
General
Inspection
WARNING Dangerous voltages are present inside the system. Do not connect the system to AC line voltage
until correct line voltage has been verified and a thorough inspection of the system has been per-
formed.
To perform the general inspection
1. Inventory the shipment against the packing list.
2. Inspect the video monitor for damage.

Table of Contents

Other manuals for Philips iE33

Related product manuals