4535 611 98931 iE33 Service Manual Page 138
CSIP Level 1 Installation: Connectivity Worksheet
Table 5-7 Connectivity Worksheet
Information Needed
Information Supplied by
Customer Comments
General description of
DICOM device to which the
iE33 is to be connected
❏ DICOM Printer (direct
connect, no network)
❏ DICOM Printer (via
network)
❏ DICOM Archive Server
❏ DICOM Commit Server
❏ DICOM PPS Server
❏ DICOM Worklist Server
❏ DICOM Structured Report
Server
❏ Analog Printer
More than one type of server
can be selected.
Some servers may be on
different ports. If so, this
should be indicated.
Maximum Network Speed.
Does the customer’s system
operate at 100 Mbsp/Full
Duplex?
❏ Ye s
❏ No
If Yes, FSE may be required to
manually set the network card
speed in Tech Admin.
Manufacturer and Model
Number of the printer
If above selection was a
printer.
For all connections through a network, the following is minimum information” Note: iE33 does
not support DHCP (dynamic IP addressing)
To Next Page
Loading...