4535 611 989314730-0047-01iE33 Service Manual Page 323
CSIP Level 1 Disassembly: Disassembly Procedures
System Power Cord (100/120 V and 230 V)
Figure 10-63 System Power Cord Warnings
WARNINGS
• The power cord must be fully inserted into the AC receptacle on
the AC tray.
• The retention bracket must be oriented properly to accommodate
the power cord being installed.
• The retention bracket must be pushed firmly up against the power
cord connector body.
• Do not bend the power cord around the retention bracket.
• Fully remove the retention bracket before servicing the AC power
cord or AC tray.
Read all warnings (Figure 10-63) before
proceeding with power cord disassembly
or assembly procedures.
NOTE The power cord configuration
differs between 100/120-V
(Figure 10-65) and 230-V sys-
tems (Figure 10-66).
Return to .Disassembly Procedure List
(2 of 2)
To Next Page
Loading...