Philips iE33 - Adding DICOM Printers or Servers

4535 611 98931 iE33 Service Manual Page 126
CSIP Level 1 Installation: Connectivity Information
NOTES
• The values entered for Station Name and System Location must match the correspond-
ing Modality Worklist field values. These fields can be left blank if the station name or sys-
tem location are not being used in the worklist or if no worklist server is configured. Consult
with the Network Administrator for more information
• The iE33 does not have DHCP (dynamic IP addressing) capability. IT must provide a static IP
address.
Adding DICOM
Printers or
Servers
➤ To add a network device (printer, server, or archive device)
1. Press Setups (on the keyboard).
2. Click Print/Network.
3. Click the Global Config tab.
4. Click Devices.
5. Click New Device.
6. Use the pull-down menu to select the device type or type in the device type.
7. Configure the new device by entering the following:
NOTE All of the following fields are required.
- Printer Type (only if you are adding a printer)
- Device Name
- AE Title (case sensitive)
-Port #
- IP Address