4535 611 98931 iE33 Service Manual Page 213
CSIP Level 1 Adjustments: Control Panel Lateral Translation Force Adjustment
17. Verify that the calibration succeeded:
a. Press Tr ans du cer.
b. Select a transducer and a preset.
c. If you are unable to select a transducer and a preset, reboot the system and repeat step 1
through step 17.
Control Panel
Lateral Trans-
lation Force
Adjustment
The control panel lateral translation force and rotational torque settings are adjusted simulta-
neously.
➤ To adjust the lateral translation force and rotational torque setting
1. Remove the 10 panhead screws securing the front pivot (orange) cover from under the con-
trol panel.
2. Check the force necessary to rotate the control panel and adjust if necessary.
3. Using an allen wrench, adjust the screw shown in Figure 7-5. Adjust for customer satisfac-
tion. There is no torque specification for this adjustment.
4. Replace cover.
To Next Page
Loading...