Philips iE33 - Printer

4535 611 98931 iE33 Service Manual Page 202
CSIP Level 1 Performance Tests: Peripherals
5. Rewind the tape to the beginning of the current recording.
6. Play back the video and verify that the graphics and gray bar on the display are in sharp focus
and that the gray bar displays the full range of gray shades as seen on the monitor.
7. Verify that the displayed image is spatially correct, horizontally and vertically.
Printer ➤ To test printer operation
1. Press Setups.
2. Click Print/Network.
3. Click the Device Selection tab.
4. Select the installed printer.
5. Connect and initialize any transducer.
6. Acquire a 2D image.
7. Press Freeze.
8. Press Print. Verify that the print contains region of interest and full-screen images.
9. Touch Alt Print. Verify that the print contains region of interest and full-screen images.
10. Verify that the graphics and gray bar on the print are in sharp focus and that the gray bar dis-
plays the full range of gray shades as seen on the monitor.
11. Verify that the print image is spatially correct, horizontally and vertically.