EasyManuals Logo

Xerox WorkCentre 6505 Service Manual

Xerox WorkCentre 6505
793 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #571 background imageLoading...
Page #571 background image
Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 8-123
Service Parts Disassembly
14. Remove the screw (silver, 4mm) that secures the USB connector on the Image
Processor Board to the I/O Plate.
15. Remove two screws (silver, 6mm) that secure the IP Board to the rear panel
and separate the two pieces.
Replacement Note
When installing a new IP Board, move the NVRAM and, if installed, the
Memory Card from the old IP Board to the new IP Board. Note NVRAM chip
orientation in the socket when removing and replacing the device
s6500-307

Table of Contents

Other manuals for Xerox WorkCentre 6505

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 6505 and is the answer not in the manual?

Xerox WorkCentre 6505 Specifications

General IconGeneral
Print TechnologyLaser
Copy ResolutionUp to 600 x 600 dpi
Standard Paper Capacity250 sheets
ADF Capacity35 sheets
FunctionsPrint, Copy, Scan, Fax
Processor533 MHz
Memory256 MB
Fax Transmission Speed33.6 kbps
Monthly Duty Cycle40, 000 pages
ConnectivityUSB 2.0, Ethernet 10/100Base-TX
Maximum Paper Size8.5 x 14 in
Operating System CompatibilityWindows, Mac, Linux
Print ResolutionUp to 1200 x 2400 dpi

Related product manuals