Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 8-155
Service Parts Disassembly
MFP AC Power Inlet and Power Switch Harness
MFP PL8.3.7 (Switch Assy Inlet MG AIO [110V & 220V])
1. Perform the service preparation steps on page 8-3.
2. Open the Front Cover.
3. Remove the MFP Left Side Cover (page 8-37).
4. Remove the Outer Pole Cover (page 8-39).
5. Remove the MFP Right Side Cover (page 8-40).
6. Remove the MFP Rear Cover (page 8-43).
7. Remove the MFP Top Cover (page 8-45).
8. Remove the LVPS Card Cage (page 8-64).
9. Remove the screw (silver, with washer, 6mm) that attaches the grounding
terminal to the frame.
To Next Page
Loading...
