Cisco Nexus 7000 Series - Clear Eou

clear eou
To clear Extensible Authentication Protocol over User Datagram Protocol (EAPoUDP) sessions, use the clear
eou command.
clear eou {all| authentication {clientless| eap| static}| interface ethernet slot / port| ip-address ipv4-address|
mac-address mac-address| posturetoken type}
Syntax Description
Specifies all EAPoUDP sessions.all
Specifies EAPoUDP authentication.authentication
Specifies sessions authenticated using clientless
posture validation.
clientless
Specifies sessions authenticated using EAPoUDP.eap
Specifies sessions authenticated using statically
configured exception lists.
static
Specifies an interface.
interface ethernet slot/port
Specifies an IPv4 address. in the A.B.C.D format.
ip-address ipv4-address
Specifies a MAC address.
mac-address mac-address
Specifies a posture token name.
posturetoken type
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must enable EAPoUDP by using the feature eou command before using the clear eou command.
This command does not require a license.
Cisco Nexus 7000 Series Security Command Reference
79
C Commands
clear eou