Cisco Nexus 7000 Series - Feature Dot1 X

feature dot1x
To enable the 802.1X feature, use the feature dot1x command. To revert to the default, use the no form of
this command.
feature dot1x
no feature dot1x
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must use the feature dot1x command before you configure 802.1X.
If you disable the 802.1X feature, all 802.1X configuration is lost. If you want to disable 802.1X
authentication, use the no dot1x system-auth-control command.
Note
This command does not require a license.
Examples
This example shows how to enable 802.1X:
switch# configure terminal
switch(config)# feature dot1x
This example shows how to disable 802.1X:
switch# configure terminal
switch(config)# no feature dot1x
Related Commands
DescriptionCommand
Displays 802.1X status information.show dot1x
Cisco Nexus 7000 Series Security Command Reference
321
F Commands
feature dot1x