Cisco Nexus 7000 Series - Object-Group Udp Relay Ip Address

object-group udp relay ip address
To configure an object group that consists of destination IP addresses to which the packets are forwarded, use
the object-group udp relay ip address command.
object-group udp relay ip address object-grp-name
no object-group udp relay ip address object-grp-name
Syntax Description
Specifies the name of the object group.
object-grp-name
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the UDP relay feature by using the ip forward-protocol udp command.
You can create up to 4096 object groups.
Examples
This example shows how to configure the object group:
switch# configure terminal
switch(config)# ip forward-protocol udp
switch(config)# object-group udp relay ip address udprelay1
This example shows how to delete the the object group:
switch(config)# no object-group udp relay ip address udprelay1
Related Commands
DescriptionCommand
Enables the UDP relay feature.ip forward-protocol udp
Cisco Nexus 7000 Series Security Command Reference
524
O Commands
object-group udp relay ip address