tacacs-server deadtime
To set a periodic time interval where a nonreachable (nonresponsive) TACACS+ server is monitored for
responsiveness, use the tacacs-server deadtime command. To disable the monitoring of the nonresponsive
TACACS+ server, use the no form of this command.
tacacs-server deadtime minutes
no tacacs-server deadtime minutes
Syntax Description
Time interval in minutes. The range is from 1 to 1440.
time
Command Default
0 minutes
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
Setting the time interval to zero disables the timer. If the dead-time interval for an individual TACACS+
server is greater than zero (0), that value takes precedence over the value set for the server group.
When the dead-time interval is 0 minutes, TACACS+ server monitoring is not performed unless the TACACS+
server is part of a server group and the dead-time interval for the group is greater than 0 minutes.
You must use the feature tacacs+ command before you configure TACACS+.
This command does not require a license.
Examples
This example shows how to configure the dead-time interval and enable periodic monitoring:
switch# configure terminal
switch(config)# tacacs
-server deadtime 10
This example shows how to revert to the default dead-time interval and disable periodic monitoring:
switch# configure terminal
switch(config)# no tacacs
-server deadtime 10
Cisco Nexus 7000 Series Security Command Reference
941
T Commands
tacacs-server deadtime
To Next Page
Loading...
