Cisco Nexus 7000 Series - Ip Arp Inspection Log-Buffer

ip arp inspection log-buffer
To configure the Dynamic ARP Inspection (DAI) logging buffer size or the number of logs per interval, use
the ip arp inspection log-buffer command. To reset the DAI logging buffer to its default size, use the no
form of this command.
ip arp inspection log-buffer {entries number| logs number}
no ip arp inspection log-buffer {entries number| logs number}
Syntax Description
Specifies the buffer size in a range of 0 to 1024
messages.
entries number
Specifies the number of logs per interval in a range
of 0 to 1024 entries.
logs number
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
By default, the DAI logging buffer size is 32 messages.
This command does not require a license.
Examples
This example shows how to configure the DAI logging buffer size:
switch# configure terminal
switch(config)# ip arp inspection log-buffer entries 64
switch(config)#
This example shows how to configure the number of logs for Dynamic ARP Inspection:
switch# configure terminal
switch(config)# ip arp inspection log-buffer logs 6
switch(config)#
Cisco Nexus 7000 Series Security Command Reference
382
I Commands
ip arp inspection log-buffer