Cisco Nexus 7000 Series - Set Precedence (Policy Map Class)

set precedence (policy map class)
To set the precedence value for IPv4 and IPv6 packets in a control plane policy map, use the set precedence
command. To revert to the default, use the no form of this command.
set precedence [tunnel] {prec-value| critical| flash| flash-override| immediate| internet| network| priority|
routine}
no set precedence [tunnel] {prec-value| critical| flash| flash-override| immediate| internet| network|
priority| routine}
Syntax Description
(Optional) Sets the precedence in a tunnel
encapsulation.
tunnel
Numerical value for DSCP precedence in the control
plane policy map. The range is from 0 to 7.
prec-value
Specifies critical precedence equal to precedence
value 5.
critical
Specifies flash precedence equal to precedence value
3.
flash
Specifies flash override precedence equal to
precedence value 4.
flash-override
Specifies immediate precedence equal to precedence
value 2.
immediate
Specifies internet precedence equal to precedence
value 6.
internet
Specifies network precedence equal to precedence
value 7.
network
Specifies priority precedence equal to precedence
value 1.
priority
Specifies routine precedence equal to precedence
value 0.
routine
Command Default
0 or routine
Command Modes
Policy map class configuration
Cisco Nexus 7000 Series Security Command Reference
659
S Commands
set precedence (policy map class)