Cisco Nexus 7000 Series Command Reference

cts dot1x
To enable Cisco TrustSec authentication on an interface and enter Cisco TrustSec 802.1X configuration mode,
use the cts dot1x command. To revert to the default, use the no form of this command.
cts dot1x
no cts dot1x
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command is not supported for F1 Series modules and F2 Series modules.
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
After using this command, you must enable and disable the interface using the shutdown/no shutdown
command sequence for the configuration to take effect.
This command requires the Advanced Services license.
Examples
This example shows how to enable Cisco TrustSec authentication on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# cts dot1x
switch(config-if-cts-dot1x)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
This example shows how to disable Cisco TrustSec authentication on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no cts dot1x
switch(config-if)# shutdown
switch(config-if)# no shutdown
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Cisco Nexus 7000 Series Security Command Reference
65
C Commands
cts dot1x

Cisco Nexus 7000 Series Specifications

General

Chassis	Modular
Operating System	Cisco NX-OS
Latency	Sub-microsecond
IPv6 Support	Yes
Redundancy	Power supplies, fans, supervisors, fabric modules
Power Supply	AC or DC
Layer Support	L2, L3
Network Management	CLI, SNMP
Virtualization	VRF, vPC
Ports	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Fibre Channel, Fibre Channel over Ethernet (FCoE)
Supported Modules	Various (1G, 10G, 40G, 100G)
Features	FCoE, OTV, LISP
MPLS Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, Cisco TrustSec, Control Plane Policing (CoPP)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5 to 95% noncondensing
MTBF	Varies by model
Number of Slots	Varies by model (9-slot, 10-slot, 18-slot)