Cisco Nexus 7000 Series - Accept-Lifetime

accept-lifetime
To specify the time interval within which the device accepts a key during a key exchange with another device,
use the accept-lifetime command. To remove the time interval, use the no form of this command.
accept-lifetime [local] start-time [duration duration-value| infinite| end-time]
no accept-lifetime [local] start-time [duration duration-value| infinite| end-time]
Syntax Description
(Optional) Specifies that the device treats the
configured times as local times. By default, the device
treats the start-time and end-time arguments as UTC.
local
Time of day and date that the device begins accepting
the key.
For information about the values for the start-time
argument, see the “Usage Guidelines” section.
start-time
(Optional) Specifies the length of the lifetime in
seconds. The maximum length is 2147483646 seconds
(approximately 68 years).
duration duration-value
(Optional) Specifies that the key never expires.infinite
(Optional) Time of day and date that the device stops
accepting the key.
For information about the values for the time of day
and date arguments, see the “Usage Guidelines”
section.
end-time
Command Default
infinite
Command Modes
Key configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
By default, the device interprets all time range rules as UTC.
Cisco Nexus 7000 Series Security Command Reference
5
A Commands
accept-lifetime