Cisco Nexus 7000 Series - Eou Initialize

eou initialize
To initialize Extensible Authentication Protocol over User Datagram Protocol (EAPoUDP) sessions, use the
eou initialize command.
eou initialize {all| authentication {clientless| eap| static}| interface ethernet slot / port| ip-address
ipv4-address| mac-address mac-address| posturetoken name}
Syntax Description
Initializes all EAPoUDP sessions.all
Initializes EAPoUDP sessions for a specific
authentication types.
authentication
Specifies sessions authenticated using clientless
posture validation.
clientless
Specifies sessions authenticated using EAPoUDP.eap
Specifies sessions authenticated using statically
configured exception lists.
static
Initializes the EAPoUDP sessions for a specific
interface.
interface ethernet slot/port
Initializes the EAPoUDP sessions for a specific IPv4
address.
ip-address ipv4-address
Initializes the EAPoUDP sessions for a specific MAC
address.
mac-address mac-address
Initializes the EAPoUDP sessions for a specific
posture token.
posturetoken name
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Cisco Nexus 7000 Series Security Command Reference
296
E Commands
eou initialize