ip dhcp redirect-response
To enable the DHCP redirect response feature, use the ip dhcp redirect-response command on the DHCP
server-facing interface. To disable this feature, use the no form of this command.
ip dhcp redirect-response
no ip dhcp redirect-response
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.8.2(1)
Usage Guidelines
DHCP redirect response feature is supported only on the Cisco M3 Series modules.
To use this command, you must enable the DHCP feature using the feature dhcp command.
You can configure the ip dhcp redirect-response command on any SVI or L3 interfaces.
Examples
This example shows how to configure DHCP redirect response feature:
switch# configure terminal
switch(config)# interface Ethernet 2/1
switch(config-if)# ip dhcp redirect-response
switch(config-if)# end
Related Commands
DescriptionCommand
Enables the DHCP feature.feature dhcp
Displays the DHCP configuration details.show running-config dhcp
Cisco Nexus 7000 Series Security Command Reference
391
I Commands
ip dhcp redirect-response
To Next Page
Loading...
