Cisco Nexus 7000 Series - Ipv6 Nd Raguard Attach-Policy

ipv6 nd raguard attach-policy
To apply the IPv6 router advertisement (RA) guard feature on a specified interface, use the ipv6 nd raguard
attach-policy command in interface configuration mode.
ipv6 nd raguard attach-policy [policy-name [vlan {add| except| none| remove| all} vlan [vlan1, vlan2,
vlan3...]]]
Syntax Description
(Optional) IPv6 RA guard policy name.
policy-name
(Optional) Applies the IPv6 RA guard feature to a
VLAN on the interface.
vlan
Adds a VLAN to be inspected.add
All VLANs are inspected except the one specified.except
No VLANs are inspected.none
Removes the specified VLAN from RA guard
inspection.
remove
ND traffic from all VLANs on the port is inspected.all
(Optional) A specific VLAN on the interface. More
than one VLAN can be specified (vlan1, vlan2,
vlan3...). The range of available VLAN numbers is
from 1 through 4094.
vlan
Command Default
An IPv6 RA guard policy is not configured.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.8.0(1)
Usage Guidelines
If no policy is specified using the policy-name argument, the port device role is set to host and all inbound
router traffic (for example, RA and redirect messages) is blocked.
Cisco Nexus 7000 Series Security Command Reference
448
I Commands
ipv6 nd raguard attach-policy