Cisco Nexus 7000 Series - Eou Timeout

eou timeout
To configure timeout intervals for the global Extensible Authentication Protocol over User Datagram Protocol
(EAPoUDP) timers or for the EAPoUDP timers for an interface, use the eou timeout command. To revert to
the default, use the no form of this command.
eou timeout {aaa seconds| hold-period seconds| retransmit seconds| revalidation seconds| status-query
seconds}
no eou timeout {aaa| hold-period| retransmit| revalidation| status-query}
Syntax Description
Specifies the AAA timeout interval. The range is from
0 to 60 seconds.
Setting the AAA timeout interval to zero (0)
disables the AAA timer.
Note
aaa seconds
Specifies the hold timeout interval. The range is from
60 to 86400 seconds.
hold-period seconds
Specifies the retransmit timeout interval. The range
is from 1 to 60 seconds.
retransmit seconds
Specifies the period automatic revalidation timeout
interval. The range is from 5 to 86400 seconds.
revalidation seconds
Specifies the status query timeout interval. The range
is from 10 to 1800 seconds.
status-query seconds
Command Default
Global AAA timeout interval: 60 seconds (1 minute)
Global hold-period timeout: 180 seconds (3 minutes)
Global retransmit timeout interval: 3 seconds
Global revalidation timeout interval: 36000 seconds (10 hours)
Global status query timeout interval: 300 seconds (5 minutes)
Interface timeout intervals: Global configuration values
Command Modes
Global configurationInterface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Cisco Nexus 7000 Series Security Command Reference
309
E Commands
eou timeout