Cisco Nexus 7000 Series - Show Startup-Config Dot1 X

show startup-config dot1x
To display 802.1X configuration information in the startup configuration, use the show startup-config dot1x
command.
show startup-config dot1x
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must enable the 802.1X feature by using the feature dot1x command before using this command.
This command does not require a license.
Examples
This example shows how to display the 802.1X information in the startup configuration:
switch# show startup-config dot1x
version 4.0(1)
Cisco Nexus 7000 Series Security Command Reference
903
Show Commands
show startup-config dot1x